WebPRODUCT NAME: AMERCOAT 65 THINNER SECTION 10 - STABILITY AND REACTIVITY STABILITY: This product is normally stable and will not undergo hazardous reactions. … WebJun 30, 2014 · Volume of thinner • Up to 5% can be added if desired • THINNER 21-06 ( PPG HI-TEMP THINNER 11 / AMERCOAT 65) • THINNER 91-10 or PPG HI-TEMP THINNER 10 (VOC compliant) Note: Spray application is recommended but when spray painting is not possible, brush or roller is an appropriate application method. The coating should be …
Thinners - PPG Paints
WebPage 5/7 Airless spray Recommended thinner - application to ambient substrate below 66°C (150°F) • THINNER 21-06 (PPG HI-TEMP THINNER 11/AMERCOAT 65) • THINNER 91-10 or PPG HI-TEMP THINNER 10 (VOC compliant) Recommended thinner - application to hot substrate at 66°C (150°F) up to 260°C (500°F) Web(Thinner 60-12), Amercoat 65 (Thinner 21-06) (d) POT LIFE: 1.5 Hr(s) @ 90 °F ( 32 °C) 3.5 Hr(s) @ 70 °F ( 21 °C) 6.5 Hr(s) @ 40 °F ( 4 °C) Graphs included on page: NA (e) SPECIAL INSTRUCTIONS: NA ... (Thinner 90-58) for cleaning. IF OVERCOAT WINDOW HAS BEEN EXCEEDED FOR NON-CRITICAL APPLICATIONS: Coating surface should be clean ... restaurants in strawberry square
PPG SigmaCover 2 Amerlock 2 Metal Epoxy Coating 500
WebJun 30, 2014 · • THINNER 21-06 ( PPG HI-TEMP THINNER 11/ AMERCOAT 65) • THINNER 91-10 or PPG HI-TEMP THINNER 10 (VOC compliant) Recommended thinner - application to hot substrates 66°C to 149°C (150°F to 300°F) THINNER 21-25 or PPG HI-TEMP THINNER 5 Volume of thinner 0 – 5%, depending on required thickness and application conditions ... WebOct 1, 2024 · PPG Thinner 21 06 Amercoat 65. PPG Thinner 21 06 Amercoat 65. Posted on October 1, 2024 Post navigation. Published in PPG Thinner 21 06 Amercoat 65. Site … WebAdding too much thinner results in reduced sag resistance and slower cure. Thinner should be added after mixing the components Pot Life. 4 hours at 20°C (68°F) Air Spray. Recommended Thinner: PPG Thinner 21-06. Volume of thinner: 15 - 20%, depending on required thickness and application conditions. Nozzle orifice: 1.6 mm (approx. 0.063 in) provisional figures meaning